Welcome to the AngelSense Support Center

Removing the battery (GPS 2 )

Note: GPS 1 (AT&T device) guidance is available here 
 
1. From the USB port (located on the bottom edge), gently lift then remove the battery cover.
 

 
 
 
2. From the notch in lower edge of the battery compartment, lift then remove the battery.
 
 
3. Reinsert the battery and then align the battery cover back onto the device. Gently press to snap the cover into place.
 
 
NOTE: When purchasing your AngelSense Kit, if no device is chosen the default device is the GPS 1 device. 
 
Related Articles:
 
Advanced Troubleshooting Steps